Skip to content

All ports

Port 4500: IPsec NAT-T

Port 4500 is used by IPsec NAT-T over UDP. Port 4500 is IPsec NAT traversal. It appears in the study tables for 200-301, SY0-701.

What runs on port 4500

IPsec NAT-T uses UDP at the application layer. IPsec NAT traversal: ESP packets are wrapped in UDP so a VPN can cross a NAT device. Traffic on this service is encrypted.

Port 4500 is IPsec NAT traversal. When a device doing network address translation sits between two IPsec peers, the tunnel traffic is wrapped in UDP on this port so the translation does not break it.

Secure alternative and common mix-ups

The study tables do not list a separate secure replacement for IPsec NAT-T. Where it has to cross a network you do not control, restrict who can reach it and carry it inside a VPN.

Ports 500 and 4500 usually go together for IPsec VPNs. The tunnel can negotiate on 500 and then move to 4500 once a NAT device is detected, so both need to be allowed.

Check port 4500 on your own network

To test a remote host from Windows, run Test-NetConnection with the host name and -Port 4500. From Linux or macOS, run nc -vz host 4500 and add -u for UDP. To see what is listening on the machine itself, use ss -tulpn on Linux or netstat -ano on Windows and look for :4500.

UDP has no handshake, so a silent probe does not prove the port is closed. No reply can mean the port is open and the service ignored the probe, or that a firewall dropped it. A scanner such as nmap with -sU reports that state as open or filtered.

Exam objectives that include it

These are the objectives whose tables list port 4500. The same row appears in the cheat sheet for each exam.

Learn 4500 together with these. They are its pair, its secure counterpart or a service that sits under the same objective.

Questions

Port 4500 carries IPsec NAT-T, which is encrypted. Open it only where the service is needed, and keep the certificates and software current.

Keep going with the ports quiz and the cheat sheets.

Start studying free

Free plan, no card.